Installation Instructions, ABB S4C, S4C+ Pendant Armor®

  1. Power-down the controller.
  2. From the back of the pendant, unthread the Velcro hand strap from the bottom of the flex pendant.
  3. Place the bumper face-up on a clean, dry surface. Place the flex pendant atop the bumper. Maneuver the hand strap through the bottom strap cut-out. Depress the E-stop button (to its lowest position).
  4. Begin by inserting the E-stop corner into the bumper. Pull the hand strap through the bumper as you go. Fully seat this corner.
  5. Next, fit the upper-right corner of the bumper to the flex pendant. It is easier to fit the back portion first—then the front.
  6. Pull the left sides of the bumper over the left side of the flex pendant. Note cut-out/notch for controller cord.
  7. From the back of the bumpered pendant, thread the hand strap through the top strap cam. Ensure positive engagement between both sections of velcro on the hand strap.
  8. Note: If your local safety requirements dictate unencumbered or direct access to the E-stop button, cut the protective rubber brow around the E-stop as your safety requirements dictate. A utility knife may be used to cut the Santoprene.
  9. Power-up the controller and reset E-stop button.
  10. Installation is complete.

Pendant Armor™ Limited Liability Statement:

SELLER WARRANTS SANTOPRENE® BUMPER PRODUCTS AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP UNDER NORMAL USE TO THE ORIGINAL BUYER FOR THE LIFETIME OF THE PRODUCT.

ACCESSORY PRODUCTS INCLUDING PLASTIC OR GLASS SCREEN PROTECTORS, HANGERS AND CRADLE ADAPTERS ARE WARRANTED AGAINST DEFECTS IN MATERIAL AND WORKMANSHIP UNDER NORMAL USE TO THE ORIGINAL BUYER FOR A PERIOD OF 90-DAYS FROM DATE OF PURCHASE. THIS LIMITED WARRANTY APPLIES ONLY TO PRODUCTS WHICH HAVE BEEN INSTALLED IN ACCORDANCE WITH THE INSTALLATION INSTRUCTIONS. IT IS THE BUYER’S RESPONSIBILITY TO INSPECT AND COMPLY WITH ALL STANDARDS RELATING TO THE USE AND OPERATION OF THIS PRODUCT.

THIS LIMITED WARRANTY SHALL BE VOID AND SELLER SHALL NOT BE LIABLE FOR ANY DAMAGES OR HELD RESPONSIBLE FOR THE QUALITY, PERFORMANCE OR SAFETY OF PRODUCTS THAT HAVE BEEN DAMAGED DUE TO ACCIDENT, NEGLIGENCE, MISUSE, OR ABUSE. SELLER’S SOLE OBLIGATION (AND THE SOLE AND EXCLUSIVE REMEDY OF THE BUYER) WITH RESPECT TO ANY PRODUCT WHICH IS PROVEN TO BE DEFECTIVE, SHALL BE THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT, AT THE SOLE OPTION OF SELLER.

SELLER SHALL NOT BE LIABLE FOR ANY DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE DEFECTIVE PRODUCT, AND UNDER NO CIRCUMSTANCES SHALL SELLER BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, SPECIAL OR PUNITIVE DAMAGES WHETHER BASED ON WARRANTY, CONTRACT OR TORT.

NO CLAIM FOR ANY BREACH OF WARRANTY HEREIN SHALL BE VALID UNLESS DELIVERED TO SELLER IN WRITING WITHIN THIRTY (30) DAYS AFTER DELIVERY OF THE PRODUCT WITH RESPECT TO WHICH THE CLAIM IS MADE.

UNLESS APPLICABLE LAW REQUIRES OTHERWISE, THIS LIMITED WARRANTY IS EXCLUSIVE AND SELLER DISCLAIMS ANY OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE.